Fitting into a standard M.2 M-Key slot, this module allows advanced, repeatable testing of M.2 devices.

Controlled from the TestMonkey GUI or any standard scripting language, the module is simple to integrate into your test plan.

The vertical orientation allows the module to fit almost any standard M.2 slot, with the drive sitting vertically. This facilitates its use in boards with little surrounding space.

With full control over every active pin, you can perform:

Full hot-swap control of the attached card
Individual control of all lanes, sideband and power pins
Glitching of any signals
Active driving of sideband signals.

This module comes with a 40cm removable interface cable and requires a separately-purchased controller.